Primo 1361 Datasheet download pdf (Page 9)

Paper shredder Primo 1501

0511 english 9

7. Troubleshooting

Pa per jam

You have fed in too much paper.

Caution!

Do not press rocker switch alter-

nately forwards/backwards

(pos. 1 / pos. 2):

Cutting unit can be damaged.

• Press and hold down rocker

switch pos. 2.

• Pa per is pus hed out.

• Se pa ra te pa per stack.

• Press rocker switch pos. 1.

• Feed pa per successively.

Cut material container full

• Red LED on control panel lights.

• Paper shredder switches off

Empty the cut material container,

because if it is too full, malfunc-

tions can occur in the cutting sys-

tem

• Tap rocker switch pos. 2.

• Empty full shredded material

container.

Shredded material container con-

tact interrupted

• Red LED on control panel lights.

• Paper shredder switches off.

• Check whether shredded

material container is correctly

inserted in bottom frame.

If other faults occur, please check the follo-

wing before calling our customer service:

• Is mains plug in ser ted?

• Is rocker switch tur ned on?

• Is the mo tor over lo aded?

al low mo tor to cool down for 15 - 20 min.

2

1

2

1

2

8. Maintenance and care

Cleaning:

• Switch off the shredder, pull out the mains

plug.

• When cleaning only use a soft cloth and a

mild soap-water solution. Never use scou-

ring agents, cleaning ﬂ uid, petroleum or

thinners.

When the cutting capacity drops or

the noise increases (Cross cut):

• Switch paper shredder off:

Tap rocker switch pos. 2.

• Spray special cutting block oil th-

rough paper feed opening across

the whole width of the cutting

system blades.

• Run cutting system backwards

(pos. 2) without feeding paper.

Paper dust and particles are

shaken off.

2

2

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 42 43

Comments to this Manuals

No comments